3D · HC105F
Inspect the lid, hinge or sliding drawer in normal use.
One open-ended folding-card sleeve holds the separately wrapped and lined rigid drawer.

Complete closed assembly envelope: 200 × 150.5 × 50.5 mm
Inspect the lid, hinge or sliding drawer in normal use.
Outside artwork prints on wrapping paper. Inside artwork prints on lining paper. Greyboard remains a separate core.
Preview colours are separate from material caliper and print-ready colour specifications.
| Blank | Material | Caliper | Per set | Order blanks | Net area / set |
|---|---|---|---|---|---|
| Folding-card insert | 0.5 mm | 1 | 100 | 0.0827 m² | |
| Greyboard core | 2 mm | 1 | 100 | 0.0607 m² | |
| Outer wrapping paper | 0.2 mm | 1 | 100 | 0.0806 m² | |
| Lining paper | 0.2 mm | 1 | 100 | 0.0585 m² |
Net areas exclude holes and overlaps between panels in the same blank. Stock sheets, waste and adhesive are separate.
Different calipers have independent sheet plans. Each component remains a distinct blank. Prepared greyboard uses the full rectangular stock for sheet yield.
Sheet sizes are format references; the model uses 0.5 mm material. Confirm stock, grain and availability in the quotation.
All materials selected for SVG, DXF and OBJ. Animated glTF and the editable record contain the complete assembly.
The dieline shows the folding blanks after corner waste removal. Use Raw stock groove DXF for the rectangular board and extended groove axes.
A single folding-card sleeve remains open at both ends; its tapered glue lap overlaps inside the shorter side. The drawer core starts as one rectangular stock blank. The nominal corner stock removal precedes the folding shown in 3D. Drawer lining is the separate STY02 cross. Measured reference dimensions and nominal assembled allowances are recorded separately. Precise V-cutter shape, groove depth and adhesive retention require a supplier sample.
Packmage drawings, dimensions, options and accessible 3D states are recorded per design. EasyPackMaker provides independent construction-family and material-fit comparisons. Matching codes do not prove matching physical designs.
Tooling grooves, residual skin, adhesive compression, hardware and physical fit still require a supplier sample. This is an independently editable construction, with source-specific differences recorded; factory equivalence is not claimed.