3D · HC105D
Inspect the lid, hinge or sliding drawer in normal use.
A five-sided sleeve contains a separately wrapped half-cut cross tray.

Complete closed assembly envelope: 201.3 × 149.1 × 50.1 mm
Inspect the lid, hinge or sliding drawer in normal use.
Outside artwork prints on wrapping paper. Inside artwork prints on lining paper. Greyboard remains a separate core.
Preview colours are separate from material caliper and print-ready colour specifications.
| Blank | Material | Caliper | Per set | Order blanks | Net area / set |
|---|---|---|---|---|---|
| Greyboard core | 2 mm | 1 | 100 | 0.0848 m² | |
| Outer wrapping paper | 0.2 mm | 1 | 100 | 0.0965 m² | |
| Greyboard core | 2 mm | 1 | 100 | 0.0554 m² | |
| Outer wrapping paper | 0.2 mm | 1 | 100 | 0.0744 m² | |
| Lining paper | 0.2 mm | 1 | 100 | 0.0534 m² |
Net areas exclude holes and overlaps between panels in the same blank. Stock sheets, waste and adhesive are separate.
Different calipers have independent sheet plans. Each component remains a distinct blank. Prepared greyboard uses the full rectangular stock for sheet yield.
Sheet sizes are format references; the model uses 2 mm material. Confirm stock, grain and availability in the quotation.
All materials selected for SVG, DXF and OBJ. Animated glTF and the editable record contain the complete assembly.
The rear closure is integral with the sleeve strip; no separate rear-cap blank is added. The greyboard drawer uses a cut-cross/half-cut core, separate cross wrap and optional cross liner. Rectangular corner-groove stock is not substituted. This is an independently reconstructed editable material model. V-groove width/depth, half-cut residual skin, adhesive film, ribbon retention and sliding friction are nominal; source or factory equivalence is not asserted.
Packmage drawings, dimensions, options and accessible 3D states are recorded per design. EasyPackMaker provides independent construction-family and material-fit comparisons. Matching codes do not prove matching physical designs.
Tooling grooves, residual skin, adhesive compression, hardware and physical fit still require a supplier sample. This is an independently editable construction, with source-specific differences recorded; factory equivalence is not claimed.